Re: [RC] modifying stirrup leathers on BM Sport Saddle (BMSS) - Dolores Arste
I use webbers on my Sports saddle. I cut the
stitching on the Webbers and then cut them to the right length (hint, I used
child size length to start). Then I drilled two holes in the spot where they
need to be attached to the stationary stirrup ring. I used Chicago screws to
hold them in place. Once I was happy with the length I put automotive "sleeve
retainer" in the screws and screwed them on. They have held up this way for 3
years. You can also use "lock tight". Caution, don't use either until you are
sure you have them right as you will not be able to remove them once set.
Recently the Webbers have begun to show wear so I
thru a few stitches in with an awl. But, if they get too worn, just replace
them.
Do not do this with leather, the screw will
cut into the leather. I also replaced the girthing system with Beta biothane
straps (I cut biothane stirrup leathers fairly heave stuff) so I could use an
English girth (less bulk easier loosening and tightening). I also attached these
with the screws and sleeve retainer.
I bought a nice girthing system made of leather
from someone (I could look it up) but I haven't been able to put it on because I
can't get the biothane ones off ;)
