 |
Re: [RC] Cutting Stall Mats - Karen SullivanMy husband helped me cut the stall mats; he used a rotary blade power saw...it still was a struggle and pain in the neck (I held up edge of mat; we had chalked line)...until 2/3 through the project we discovered it I pulled on the cut part and held some tension, then the saw went through it like butter... Karen ----- Original Message ----- From: <Sheila_Larsen@xxxxxxx> To: <ridecamp@xxxxxxxxxxxxx> Sent: Tuesday, September 05, 2006 5:53 PM Subject: [RC] Cutting Stall Mats I know this has been discussed before and honest I did try to search the archives but gave up. One of my thick rubber mats is about 1/2 - 3/4 of an inch to wide for the area in which I want it. I know there is some bright person out there that has an easy way to cut these heavy suckers short of a chain saw. Please I beg of you, and thanks in advance. There must be some "world expert mat cutter" out there somewhere. "We stand guard over works of art, but species representing the works of eons are stolen from under our noses." Aldo Leopold. =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Ridecamp is a service of Endurance Net, http://www.endurance.net. Information, Policy, Disclaimer: http://www.endurance.net/Ridecamp Subscribe/Unsubscribe http://www.endurance.net/ridecamp/logon.asp Ride Long and Ride Safe!! =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Ridecamp is a service of Endurance Net, http://www.endurance.net. Information, Policy, Disclaimer: http://www.endurance.net/Ridecamp Subscribe/Unsubscribe http://www.endurance.net/ridecamp/logon.asp Ride Long and Ride Safe!! =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
|